They are like wood cousins on a playground.Īnd that’s it! I wish I had gotten a shot of the inside so if I ever go back and get that – I’ll update this post to show the hooks. The hood is within viewing and they both have the same finish and I think it ties everything together. I attached cup hooks on the inside for the brooms to hang and now Charity can hide all her cleaning stuff! Then Jeremy used 2″ long screws to go directly through the back and through the drywall into the studs. The plan was for this to be wall mounted and so we had to bring it inside and determine where the studs were at. Step back once in a while to make sure that you didn’t miss areas.Īttach that dark hardware for contrast and BOOM….you are almost done □ But you will want to hit the edges and the face fairly uniformly. My shoulder now looks like I use steroids because it is a WORKOUT. I used 220 sandpaper and just went at it. It doesn’t need to be completely coated because this is a distress finish.Īfter your paint is dry, you will want to sand the entire thing by hand. Then use a brush to do an imperfect coat of semi-gloss or eggshell interior paint in white. The latex gloves are a waste of time and a waste of a good manicure. Time to finish this baby! I used Rust-Oleum’s American Walnut for the base. Then I had attached the trim on the doors with glue and a brad nailer. I’ll be honest….I don’t build a lot of things with doors….hinges are a little intimidating for some reason…but these are easy. I used four of these hinges for the doors. Once your main box is built, you can attach your doors and your stop blocks. If you are allergic to nuts, just have them handy while you finish your broom closet and then mail them to… Peanut M&Ms are absolutely necessary for this build. Or when the kids ask you….tell them its a coffin □ Okay…so the first thing you do is construct your box. Since you don’t see the insides of the door panels, it wouldn’t have mattered to see that plywood edge either. It wouldn’t have affected the functionality of the closet. In actuality, I used 1×12’s for the doors but I wouldn’t recommend that as it is cheaper to just use plywood for the doors and it would have been nicer if it was just a inch or so wider. I modified the cut list above to show what I should have done.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |